The COD Tom Lee Mu Tanji manufacturers worth trust TLXH that buy charcoal machine how to make your mind at ease? Cash on delivery reflect the good faith of the Tom Lee Mu Tanji manufacturers, and also allow customers to rest assured purchase. Learn Mutan Ji also need more knowledge: 
 Sawdust is an excellent mechanism for charcoal raw materials, Mu Tanji full set of equipment, including: the mill, the dryer system of rods, carbonization furnace. Granularity is very fine sawdust, generally between 3-6mm, so the grinder can be omitted, direct drying system of rods, the customer asked: sawdust moisture requirement is 6% -12%, then how to measure out of this humidity? 
 If you are new to this line may be good for humidity control master, Tom Lee Mu Tanji manufacturers teach you coup: the measurement of humidity of sawdust is very simple, a raw material grip with the clutch release, to observe the sawdust not have spread with adhesive humidity exceeds 12%, and is not suitable for charcoal, because the water too much on the negative, forming charcoal surface there will be cracks. Want to produce beautiful charcoal, each link is very important. 
 When it comes to the mechanism of charcoal, we all know that the dark can be used to burn something to replace coal, the use of charcoal is indeed wide, can charcoal quality is good or bad, how to measure the quality of the charcoal? Tom Lee Mu Tanji equipment manufacturer teach you methods: 
 The quality of the charcoal can only be based on the different uses of different quality indicators. Usually we are mainly from the moisture content of charcoal, volatile fraction, ash rate and fixed carbon content, calorific value to measure the quality of the charcoal. 
 Moisture content 
 Charcoal absorbent material, it is in the process of piling up, it will absorb the moisture in the air, making its own moisture content was increased. Therefore, the size of the moisture content of the charcoal for its own quality, nothing more than customer requirements moisture content of charcoal as low as possible in order to enhance its economic value. In general, fresh-baked charcoal moisture content of less than 3%. 
 Volatile fraction (volatile matter content) 
 Volatile matter content (matter) depends on the carbonization temperature. According to different purposes, we can burn low-temperature carbon, high-temperature carbon can also be burned. Release of the former high-temperature calcination of CO, CO2, H2, CH4 and gaseous carbohydrate and other volatiles, and its content is generally 12 to 20 percent. High temperature carbon released from the volatile content is generally less than 5%. 
 Ash rate (ash content) 
 The ash that is remaining after the charcoal burning all white or pink material, that is, we usually say that the gray. Its size has a direct impact on the use and economic value of the charcoal. For example, straw, rice husk and other material contained in the ash, and easy to fall off during the combustion, resulting in low combustion temperature, which is not suitable for people's lives and industrial carbon. Of course, people want the charcoal ash as small as possible in order to expand its use. 
 The ash of the charcoal carbonization process and the different temperature and different. Wood or scrap them into carbon ash difference is not large, generally speaking, the above under the same conditions, the broad-leaved forest to burn charcoal than the coniferous forest, a large proportion of bark raw material to burn The system of charcoal ash. The usual charcoal ash in 1 to 4 percent. 
 Mutan Ji www.heng-tong.com Mutan Ji equipment www.mutanj.com 
 Mu Tanji Price: 13,592,670,711 Mutan Ji information obtained from QQ: 1377702788 
 New Mutan Ji Address: Gongyi city in Henan Province groove Industrial Zone